Product Description Rapid cure time at elevated temperature.
Typical Applications Packaging Information Typical Properties Warranty- The information and data contained herein are believed to be accurate and reliable; however it is the user's responsibility to determine suitability of use. Since Shin-Etsu Silicones, Inc. cannot know all of the uses to which its products may be put or the conditions of use, it makes no warranties concerning the fitness or suitability of its products for a particular use or purpose. You should thoroughly test any proposed use of our products and independently conclude satisfactory performance in your application. Likewise, if the manner in which our products are used requires governmental approval or clearance, you must obtain it. Shin-Etsu Silicones, Inc. warrants only that its products will meet its specifications. There is no warranty of merchantability of fitness of use, nor any other expressed or implied warranties. The user's exclusive remedy and Shin-Etsu Silicones, Inc.'s sole liability is limited to refund of the price or replacement of any product shown to be otherwise than as warranted. Shin-Etsu Silicones, Inc. will not be liable for incidental or consequential damages of any kind. Suggestions of uses should not be taken as inducements to infringe any patents.
Shinetsu Silicone International Trading (Shanghai) Co., Ltd Guangzhou Branch, Tel:+86-20-3831-0212, Attn: Miss Sui No need to post, can pass EN 14350 Baby nipples Products requiring Shin-Etsu CHN-CLE-5A/B is a liquid injection molding silicone. It is supplied as two components which are mixed in a 1:1 ratio to ensure easy and accurate blending. The viscosity of CHN-CLE-5-A/B is low enough to alloweasy pumping through most injection molding systems, and no need to do post cure to REACH the VOC limit Product Features low hardness Toys 200kg Drum Kit 20kg Pail Kit No post cure LIMS CHN- CLE-5-A/B Type of HCR Viscosity A Viscosity B Durometer Tensile Strength (Mpa) Elongation (%) 100% Modulus Specific Gravity Tear crescent (KN/M) Compression Set (%) Comp. Set Time (hours) Comp. Set Temp. (deg-C) LIMS 760 780 8 6.1 920 0.2 1.08 9 32 22 175 0.3-0.5 VOC (%, EN 14350) Note: Values are not for specification purposes.